From BananaPro/Pi
Jump to: navigation, search

Other languages:
English • ‎中文(简体)‎


YS-CH341T is a multi-purpose regulator of USB to Serial port,USB to IIC.

General specifications

Volume 3.1 cm*1.8 cm
Function USB to I2C,USB to UART (TTL), STC ISP download
Voltage 3.3V or 5V
Supports serial communication modes UART mode,I2C mode
Interface USB2.0
Speed USB to UART:Baud rate from 50bps to 2 MbPS
USB to I2C Master:20K 100K 400K 750K
Internal devices USB1.1 receiver,5V to 3V Stabilizer, 12 MHz crystal oscillator
The power supply output 5V-500mA or 3.3V-100mA
Data bits 7 or 8 data bits
Working status indication green light for the UART, red light is I2C
Support system Full support for Win8, Win7, WinXp, Win2K, WinCE, Linux, Mac, systems, 32bit and 64bit system.
Support current protection Yes
Support USB Suspend state Yes
CPIO pin extension 5V pin,3.3V pin,TXD,RXD,GND,VCC
Application 1:Serial port expansion
2: Hardware debug
3:MCU burning
4: Debugging
5: Collecting data

Install and test

These operations run in the Lemuntu system
Step 1: Insert the USB to Serial adapter into LeMaker Guitar.
Step 2: Check up wether recognize the usb serial port or not through the following command.

ls /dev/ttyUSB*

When find ttyUSB0 nodes,we can explain that it has correctly identified the usb serial port module.
Step 3: Run the command below to set up USB to Serial.

sudo apt-get install minicom
sudo minicom -s

LeMaker Guitar & Base Board Rev.B
Step 4:Select a serial port settings, refer to the below.
LeMaker Guitar & Base Board Rev.B
You can use USB to serial module after setting up the usb serial port module.